JLG 600SC_660SJC Operator Manual - Manual (Page 49)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121156 – JLG Lift – 3-15
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR
SLIGHT LEVELING OF THE PLATFORM. INCORRECT USE COULD CAUSE
THE LOAD/OCCUPANT TO SHIFT OR FALL. FAILURE TO DO SO COULD
RESULT IN DEATH OR SERIOUS INJURY.
12. Platform Leveling Override
A three position switch allows the operator to adjust the
automatic self leveling system. This switch is used to
adjust platform level in situations such as ascending/
descending a grade.
13. Travel Warning Horn
A push-type HORN switch supplies electrical power to
an audible warning device when pressed.
14. Drive Orientation Override
When the boom is swung over the rear in either direc-
tion, the Drive Orientation indicator will illuminate when
the drive function is selected. Push and release the
switch, and within 3 seconds move the Drive/Steer con-
trol to activate drive or steer. Before driving, locate the
black/white orientation arrows on both the chassis and
the platform controls and match the control direction
arrow to the intended chassis direction.
15. Soft Touch Override Switch (If equipped)
This switch enables the functions that were cut out by
the Soft Touch system to operate again at creep speed,
allowing the operator to move the platform away from
the obstacle that caused the shutdown situation.
16. Soft Touch Indicator (If Equipped)
Indicates the Soft Touch bumper is against an object. All
controls are cut out until the override button is pushed,
at which time controls are active in the Creep Mode.