JLG 600SC_660SJC Operator Manual - Manual (Page 53)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121156 – JLG Lift – 3-19
8. System Distress Indicator
The light indicates that the JLG Control System has
detected a malfunction and a Diagnostic Trouble Code
has been set in the system memory. Refer to the Service
Manual for instructions concerning the trouble codes
and trouble code retrieval.
The malfunction indicator light will illuminate for 2-3 sec-
onds when the key is positioned to the on position to act
as a self test.
9. AC Generator
Indicates the generator is in operation.
10. Soft Touch Indicator
Indicates the Soft Touch bumper is against an object. All
controls are cut out until the override button is pushed,
at which time controls are active in the Creep mode.
11. Creep Speed Indicator
When the Function Speed Control is turned to the creep
position, the indicator acts as a reminder that all func-
tions are set to the slowest speed. The light flashes if the
control system puts the machine into creep speed and
will be on continuously if the operator selects creep
speed.
12. Drive Orientation Indicator
When the boom is swung beyond the rear in either
direction, the Drive Orientation indicator will illuminate
when the drive function is selected. This is a signal for
the operator to activate the Drive Orientation Override
Switch and verify the drive control direction is correct.