JLG 600SC_660SJC Operator Manual - Manual (Page 70)

SECTION 4 - MACHINE OPERATION
4-16 – JLG Lift – 3121156
4.11 HYDRAULIC TOOL CIRCUIT INSTRUCTIONS
(OPTIONAL)
Tool Circuit
To Operate: (with engine running and foot switch released).
1. Be sure hydraulic switch is in the “OFF” position.
Located on the left side of platform below console box.
2. Make sure the hydraulic tool about to be operated is at a
“safe” setting.
3. Plug tool it into quick-disconnect fittings mounted on
platform rail. The male quick connect is the pressure
feed line.
4. Set flow control knob to desired setting.