Platform control station, Platform control station -9 – JLG 600SC_660SJC Operator Manual User Manual
Page 43
SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121156
– JLG Lift –
3-9
10. Hydraulic Oil Filter Indicator
When illuminated indicates that the return oil filter is too
restrictive and needs to be replaced.
11. Transmission Pump Oil Filter Indicator
When illuminated indicates that charge pump filter is too
restrictive and needs to be replaced. This indicator has
an integral temperature sensor (70 degrees F.) so that
false signals are not generated when the hydraulic oil is
below normal operating temperature.
12. Engine Air Filter Indicator
When illuminated indicates that the air filter is too restric-
tive and needs to be replaced.
Platform Control Station
(See Figure 3-6., Platform Control Console w/Drive Orienta-
tion)
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CON-
TROL LEVERS OR TOGGLE SWITCHES CONTROLLING PLATFORM
MOVEMENT DO NOT RETURN TO THE OFF OR NEUTRAL POSITION
WHEN RELEASED.
1. Power/Emergency Stop
A two-position red mushroom shaped switch furnishes
power to PLATFORM Controls when pulled out (on).
When pushed in (off), power is shut off to the platform
functions.
Within about 2 seconds of pulling the switch out, the
machine will perform a diagnostic check of the various
electrical circuits, and if everything is OK, the platform
alarm will beep once. During this time the lights on the
indicator panel will also blink once as a bulb check.