JLG 600SC_660SJC Operator Manual - Manual (Page 64)

SECTION 4 - MACHINE OPERATION
4-10 – JLG Lift – 3121156
4.4 STEERING
Depress footswitch. Move the DRIVE/STEER control lever to
RIGHT for a turn to the right and to LEFT for a turn to the left.
BEFORE OPERATING MACHINE, MAKE SURE BOOM IS POSITIONED
OVER REAR OF CHASSIS. IF BOOM IS OVER FRONT OF THE CHASSIS,
STEER AND DRIVE CONTROLS WILL MOVE IN OPPOSITE DIRECTION
THAN INDICATED ON MACHINE PLACARDS.
4.5 PARKING AND STOWING
Park and stow machine as follows:
1. Park machine in travel position; boom lowered over rear,
all access panels and doors closed and secured, igni-
tion off, turntable locked.
2. Check that brakes hold machine in position.
3. Chock tracks front and rear.
4. Turn off SELECT switch and remove key.
5. When parking on frozen ground overnight, drive the
machine up on boards to prevent freezing to the
ground.
4.6 PLATFORM
Platform Level Adjustment
1. Leveling UP. Depress footswitch. To raise platform, posi-
tion PLATFORM LEVEL control switch UP and hold until
platform is level.
2. Leveling DOWN. Depress footswitch. To lower platform,
position PLATFORM LEVEL control switch to DOWN and
hold until platform is level.
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR
SLIGHT LEVELING OF THE PLATFORM. INCORRECT USE COULD CAUSE
THE LOAD/OCCUPANT TO SHIFT OR FALL. FAILURE TO DO SO COULD
RESULT IN DEATH OR SERIOUS INJURY.
Platform Rotation
1. Depress footswitch to rotate platform to the left, PLAT-
FORM ROTATE control is positioned to the LEFT and
held until desired position is reached.
2. Depress footswitch to rotate platform to the right, PLAT-
FORM ROTATE control is positioned to the RIGHT and
held until desired position is reached.