JLG 2505 Operator Manual - Manual (Page 70)

Section 4 - Operation
4-10 31200359
4.4 ROAD OPERATION (2505)
1. Preparation
a. Remove load from attachment.
b. Remove any large amounts of dirt from machine.
c. Check lights and mirrors and adjust if necessary.
d. Safety equipment to be carried: Warning Triangle, First Aid Kit and
Wheel Chock.
2. Lower boom. Front edge of attachment should be approximately 12-16 in
(30-40 cm) above the ground.
3. Fully tilt attachment back.
4. Place protective shield over front bucket edge: remove or reposition carriage
forks toward the machine and secure to the carriage.
5. Change steer mode to front wheel steering (1). See “Steer Mode Change” on
page 3-19.
6. Activate road use operation switch (2) to lock steer mode and joystick controlled
functions.
7. Machine is now ready for road operation.
Note: Be sure to follow all local and federal/provincial traffic regulations.
OAL2070
2 1