JLG 1250AJP Operator Manual - Manual (Page 49)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121170 – JLG Lift – 3-11
14. Jib Stow Override
Allows the operator to swing the jib to the right past the
electronic stop to stow the jib beside the boom for trans-
port.
15. Function Speed Control
Controls the speed of Boom and Swing Functions. Rotate
CCW for slower speed and CW for faster speed. To adjust to
creep, turn knob fully CCW until it clicks.
NOTE: To operate the Main Lift/Swing Joystick, pull up on the locking
ring below the handle.
NOTE: The MAIN LIFT/SWING control lever is spring-loaded and will
automatically return to neutral (OFF) position when released.
16. Main Boom Lift/Swing Controller
An infinitely proportional dual axis joystick is provided for
main lift and swing. Push forward to lift up, pull backward to
lift down. Move right to swing right, move left to swing left.
NOTE: When boom is positioned above transport position or telescoped
out and any of the following switches, DRIVE SPEED/TORQUE
SELECT or FUNCTION SPEED, are positioned to HIGH, high func-
tion speeds are automatically cut out and the machine contin-
ues to operate at a lower speed.
DO NOT OPERATE MACHINE IF DRIVE SPEED/TORQUE SELECT OR FUNCTION SPEED
SWITCHES OPERATE WHEN BOOM IS OUT OF TRANSPORT POSITION.
17. Drive Speed/Torque Select
The forward position gives maximum drive speed. The back
position gives maximum torque for rough terrain and climb-
ing grades. The center position allows the machine to be
driven as quietly as possible.