JLG 1250AJP Operator Manual User Manual

Page 53

Advertising
background image

SECTION 3 - MACHINE CONTROLS AND INDICATORS

3121170

– JLG Lift –

3-15

6.

Glow Plug/Wait to Start Indicator

NOTE:

If the engine fails to start due to cold temperatures or excessive
amounts of smoke are produced on startup, wait for the glow
plug/wait to start indicator to go out before starting the engine.

Indicates the glow plugs are operating. After turning on igni-
tion, wait until light goes out before starting engine.

7.

Footswitch/Enable Indicator

TO AVOID SERIOUS INJURY, DO NOT REMOVE, MODIFY OR DISABLE THE FOOTSWITCH
BY BLOCKING OR ANY OTHER MEANS.

FOOTSWITCH MUST BE ADJUSTED IF FUNCTIONS ACTIVATE WHEN SWITCH ONLY
OPERATES WITHIN LAST 1/4" OF TRAVEL, TOP OR BOTTOM.

To operate any function, the footswitch must be depressed
and the function selected within seven seconds. The enable
indicator shows that the controls are enabled. If a function is
not selected within seven seconds, or if a seven second lapse
between ending one function and beginning the next func-
tion, the enable light will go out and the footswitch must be
released and depressed again to enable the controls.

Releasing the footswitch removes power from all controls
and applies the drive brakes.

8.

Fuel Level Indicator

Indicates the level of fuel in the fuel tank.

9.

Creep Speed Indicator

When the Function Speed Control is turned to the creep
position, the indicator acts as a reminder that all functions
are set to the slowest speed. The light flashes if the control
system puts the machine into creep speed and will be on
continuously if the operator selects creep speed.

Advertising