JLG 4394RT Service Manual - Manual (Page 207)

SECTION 5 - JLG CONTROL SYSTEM
3121249 – JLG Lift – 5-1
SECTION 5. JLG CONTROL SYSTEM
5.1 HAND HELD ANALYZER
To Connect the Hand Held Analyzer:
1. Connect the four pin end of the cable supplied with
the analyzer, to the four position connector on the
PCB in the ground control station or at the platform
control station as shown in. Connect the remaining
end of the cable to the analyzer.
men u:
PRESS ENTER HELP:
Analyzer Display
Escape Key
To return home or access
previous menu
Enter Key
Stores and selects Top Level, Sub
Level, and item menus
Left & Right Arrow Keys
Used to move between Top Level,
Sub Level, and item menus
Up & Down Arrow Keys
Value Selector
Figure 5-1. Hand Held Analyzer
Figure 5-2. Analyzer Connection
Ground Control
Analyzer Connection
Platform Controll
Analyzer Connection