JLG 4394RT Service Manual - Manual (Page 226)

SECTION 5 - JLG CONTROL SYSTEM
5-20 – JLG Lift– 3121249
10
(LOAD)
0
1
2
NOT INSTALLED — Load Sensing System (LSS) is not fitted to the vehicle.
CUTOUT PLT — Load Sensing System (LSS) is fitted, and Platform Controls are pre-
vented in the event of an Overload. Ground Controls remain functional. This is the default
setting for CE machines.
CUTOUT ALL — Load Sensing System (LSS) is fitted. Platform and Ground Controls are
prevented in the event of an Overload.
NOTE: Certain market selections will alter default setting.
0
11
(GROUND ALARM)
0
1
2
NOT INSTALLED — Vehicle alarm will function for Overload (if LOAD enabled).
DESCENT — Vehicle alarm will function for Overload (if LOAD enabled) and during Lift
Down motion.
MOTION — Vehicle alarm will function for Overload (if LOAD enabled), during Drive
motion, and during Lift motion.
NOTE: Certain market selections will alter default setting.
2
12
(ENGINE SHUTDOWN)
0
1 NO - The engine will not be automatically shutdown.
SHUTDOWN - The engine will automatically shutdown in the event of high engine coolant
temperature, low oil pressure, or a temperature sensor or oil pressure sensor fault.
1
4150390 J
Table 5-4. Machine Tilt Configuration
Model Market LImits
33RT 2WD,
33RT 4WD
ANSI USA
Lift Up and Drive prevented when Elevated and Tilted beyond the following limits:
Front to Back: ±5° to Full Height
Side to Side: ±5° to 26 Feet; ±4° to 30 Feet; ±3° to Full Height
ANSI EXPORT Same as ANSI USA
CSA
Lift Up and Drive prevented when Elevated and Tilted beyond the following limits:
Front to Back: ±3° to Full Height
Side to Side: ±3° to Full Height
CE
Tilt Lamp energized when Tilted beyond the following limits:
Front to Back: ±5° to Full Height
Side to Side: ±3° to Full Height
AUSTRALIA Same as ANSI USA
43RT 2WD
43RT 4WD
ANSI USA
Lift Up and Drive prevented when Elevated and Tilted beyond the following limits:
Front to Back: ±5° to Full Height
Side to Side: ±5° to 30 Feet; ±4° to 36 Feet; ±3° to Full Height
ANSI EXPORT Same as ANSI USA
CSA
Lift Up and Drive prevented when Elevated and Tilted beyond the following limits:
Front to Back: ±3° to Full Height
Side to Side: ±3° to Full Height
CE
Tilt Lamp energized when Tilted beyond the following limits:
Front to Back: ±5° to Full Height
Side to Side: ±3° to Full Height
AUSTRALIA Same as ANSI USA
4150390 J
NOTE: Vehicle Tilt Configuration based on Model and Market Settings
Table 5-3. Machine Configuration Programming Information
Configuration Digit Setting Description Default Number