JLG X390AJ Operator Manual - Manual (Page 54)

SECTION 4 - MACHINE OPERATION
4-10 – JLG Lift – 3128792
If the functions are selected when one of the above listed con-
ditions is missing, an error message will appear on the plat-
form/remote control LCD display indicating which of the
conditions are OK and which are not. If the condition is that an
outrigger is not set properly, the message will also indicate
which outrigger is not set properly.
ST1: if OK outrigger 1 is set properly.
ST2: if OK outrigger 2 is set properly.
ST3: if OK outrigger 3 is set properly.
ST4: if OK outrigger 4 is set properly.
INCL: if OK the machine is set up on an accepted slope.
LOAD: if OK the load in the platform is acceptable.
PLATFORM: if OK the platform/remote control box is in the
proper location in the platform.
PEDAL: If OK the footswitch is correctly depressed.
Setting Outriggers From the Platform/Remote
Console
(Reference Figure 4-3. for item numbers)
Either - Press and hold the outrigger auto-
set and level button 7 (item 7) until OK
appears on the platform LCD display.
or
Operate each outrigger separately by
pressing button 2 (item 2) to select which
outrigger to control (each outrigger is num-
bered 1 thru 4, see decal, each press of but-
ton 2 displays the outrigger selected on the
LCD display). Press button 1 (item 1) to
retract or button 7 (item 7) to set that outrig-
ger. The OK will appear on the display when
the outriggers are set properly and the unit
is level.
Note: To cycle back to outrigger auto-set
mode, press button 2 (item 2) until the LCD
display shows the normal operating icons.
AUTO
7
MANUAL
SELECT
2