JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 19)

Form No. 20136 3/03 • TF6-42 Owner/Operator Manual
OPERATOR’S CAB
The cab permits vision from all sides and includes an overhead guard to
provide protection from falling objects.
A fully-enclosed cab with windows and a lockable door is available as an option.
The top half of the cab door must be secured in either the fully-opened or
closed position. The bottom half of the cab door must be secured in the closed
position only. Be sure the door is fully secured when operating the handler.
The operator’s seat is equipped with a seat belt and includes fore and aft
adjustment to compensate for variations in operator size. The adjustment
release/lock is located on the side of seat. Wear seat belt when operating
machine.
An optional windshield wiper/washer is available for use with enclosed cabs. A
control switch is located on the instrument panel.
A variable-speed defroster fan is available for use with enclosed cabs. An “On/
Off” control switch and speed control are located on the base of the fan.
The heater fan speed is controlled by a knob on the panel to the right of the
operator’s seat. Hot water to the heater can be controlled by a knob on the
same panel or a valve in the engine compartment.
The operator’s cab is an S.A.E. “FOPS/ROPS” structure. Do not make
any modification to this structure. If damaged, the cab cannot be
repaired. It must be replaced.
CONTROL AND INSTRUMENT IDENTIFICATION
Figure 3-1
OPERATOR’S CAB
3.0
NOTE!
Relevant S.A.E. Recommended
Practices:
S.A.E. J1040 for ROPS
S.A.E. J231 for FOPS
WARNING !
Any modification to this machine
must be approved by JLG/GRADALL
to assure compliance with FOPS/
ROPS certification for this cab/
machine configuration.
WARNING !
Never operate the handler unless
the overhead guard is in good
condition.
MACHINE MUST BE IN NEUTRAL AND PARK BRAKE ON TO START
R
ST AR T
IGNITION
240
100
F
E
80
0
16
10 TEMP
FUEL OIL
VOLTS - + 0 0 0 0 0 0
QUARTZ
48" & 72" CARRAIGE
48" & 72" CARRAIGE
48" & 72" CARRAIGE
TRANSMISSION
CONTROL LEVER
(FORWARD/REVERSE/GEAR
CHANGE LEVER)
AUX CONTROL LEVER
(OPTIONAL)
LEVEL
INDICATOR
HOURMETER
STEERING
WHEEL
PARK BRAKE
SWITCH
BOOM CONTROL
JOYSTICK
OIL PRESSURE/
COOLANT TEMP/
VOLTMETER/
FUEL GAUGE
HORN BUTTON
CAPACITY CHARTS
STEER SELECT SWITCH
START/AUX. POWER
SWITCH
ACCELERATOR PEDAL
BRAKE PEDAL
CONTROL STATION
SELECTOR SWITCH
TRANS TEMP WARNING LIGHT
EMERGENCY STOP SWITCH
MICROPROCESSOR
CONTROLLER