JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 46)

15.8
WARNING !
Do not use the Personnel Work
Platform until you study &
understand the “ Capacity
Chart”. If your handler does not
have the correct “Personnel
Work Platform Capacity Chart”,
ask your supervisor to get one
before using the attachment.
WARNING !
Do not switch control for platform
to cab with personnel in platform
except in emergency.
“Transformer Series” Personnel Work Platform
(with controls on Platform)
For proper operation of the “Transformer Series” Platform, refer to the
appropriate Owner/Operator manual P/N 9150-4004 located at the back
of this manual and included with the attachment prior to using the
platform.
Capacity:
Refer to capacity decal on platform and capacity indicator located on control
console. The load includes personnel, materials, tools, etc. The maximum
capacity of your work platform is based on specific model material handler/
work platform combination. To determine maximum load capacity for given
operating ranges, consult the proper load capacity chart (furnished with
platform) for the material handler and work platform in use. If your handler
is not equipped with the proper personnel work platform capacity
chart, get one before using the attachment.
Installation Procedure:
1. Remove carriage/fork combination or other attachment from boom head.
See page 14.0 & 14.1.
Changing controls for operation from platform:
In Cab:
• Control Station Selector switch should be set to platform operation.
• Emergency Stop button must be pulled up.
• Steer Select Switch should be set to front wheel steer.
• Transmission control lever should be set to neutral with 1st gear selected.
Proceed to work platform
• When starting engine, the footswitch must be in the released (up) position.
• Push “UP” on Engine Start/Auxiliary Power switch to start engine. If engine
fails to start within 20 seconds, release Engine Start/Auxiliary Power switch
and allow starting motor to cool for a few minutes before trying again.
In Platform Mode:
• Maximum travel speed is 3.5 MPH with boom retracted and lowered (travel
position).
• When boom is extended approximately 3.5 feet and/or raised above 7°, the
machine will slow to creep mode (.5 MPH).
• When in creep mode and returning boom to travel position, the travel control
must be returned to neutral and reactivated to increase speed above .5 MPH.
WARNING !
The TF6-42 Handler is designed
as a single station operation
machine. Do not allow anyone in
cab while machine is being operated
in platform mode, and restrict
personnel from the work platform
while traveling or operating from
cab.
ATTACHMENTS