JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 38)

ATTACHMENTS
15.0
Approved Attachments
Several JLG/GRADALL-approved attachments are available for use with your
material handler. Contact your JLG/GRADALL Distributor or JLG/Gradall for
information on approved attachments designed to solve special material
handling problems.
The serial number plate lists attachments approved for use with your
Transformer Series Material Handler. However, there may be additional approved
attachments available. Contact your JLG/GRADALL Distributor for further
information.
Non-Approved Attachments
Do not use non-approved attachments for the following reasons:
• JLG/GRADALL cannot establish range and capacity limitations for “will fit”,
homemade, altered, or other non-approved attachments.
• An overextended or overloaded handler can tip over with little or no warning
and cause serious injury or death to the operator and/or those working near
the handler.
• JLG/GRADALL cannot assure the ability of a non-approved attachment to
perform its intended function safely.
• Non-approved attachments may cause structural or other damage to the
handler. Such damage could cause dangerous operating conditions resulting
in serious injury or death.
Carriage/Fork Capacities
The standard carriage/fork capacity chart (located on the dashboard) indicates
maximum reach and load capacities for handlers equipped with an approved
carriage/fork combination. These limitations apply to standard, JLG/
GRADALL-approved carriage/fork combinations, except as stated on
the capacity chart.
Non-standard carriage/fork combinations (greater or lesser capacity) may be
furnished by JLG/GRADALL at customer’s request or may be available for
installation because they were furnished for a different application.
If a carriage/fork combination of lesser capacity is used, the overall machine
capacity is reduced to carriage/fork capacity as indicated on carriage/fork
serial number plate.
If a carriage/fork combination of greater capacity is used, the overall machine
capacity may be reduced because of additional attachment weight and/or other
considerations. Contact your local JLG/GRADALL Distributor to determine
capacity limitations.
Attachments which have not been
approved for use with your handler
could cause machine damage or
an accident resulting in injury or
death.
The capacity of forklift, attachment
and fork combination may be less
than the capacity shown on
attachment. Consult forklift
nameplate and also ensure forks
are of proper size.
Forks rated less than the
attachment capacity decrease
capacity of attachment to that of
forks. Forks rated more than
attachment capacity do not
increase attachment capacity.
CAUTION !
WARNING !