JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 78)

P6.0
CHECKS BEFORE OPERATING
If structural damage is found or the
Quick Switch™ is not properly
engaging, do not use the material
handler or platform until the proper
repairs have been made.
WARNING !
WARNING !
Before use of the boom/platform,
the operator shall check for
overhead obstructions and
electrical conductors. Serious
injury or death could result.
Be sure to service the Material Handler in accordance with the
“Lubrication and Routine Maintenance” schedule, located in the TF6-
42 Owner/Operator Manual.
These checks and services are to be performed in addition to those specified
in the Owner/Operator Manual for the material handler. Prior to using the
material handler with the JLG/Gradall personnel work platform attached,
perform the following checks:
• Do not use the platform until it is properly secured to the
Quick Switch™. See attachment installation procedures
on page P5.1 & P5.2.
• Inspect all platform and handler structural members for signs
of damage. Do not use the platform or handler if damage is
found.
• Inspect all warning and instructional decals to ensure they are
legible and clean. Replace as necessary.
• Inspect access gate hinges and latch for proper operation,
damage and security. Do not use the platform if damaged or if
latch is inoperable.
• Check the condition of the boom extend cables/chains, boom
hoses, and their anchor points. If they are found to be out of
adjustment, badly worn, damaged, or not anchored properly,
perform necessary boom maintenance before using machine.
• Check to ensure the tires are properly inflated and surface can
support the machine.
• Check jobsite and weather conditions. Do not lift personnel
during thunderstorms, strong winds or other inclement
weather.
• Check work area for overhead hazards such as electric
conductors, bridge cranes, and other potential hazards.
• Identify the lanyard anchorage point(s) and securely attach
lanyard of an approved fall protection device. Attach only one
lanyard per anchorage point.
• Check platform and control console for damage, loose or
missing parts, and security.
• Check control switches, levers and electrical connections for
tightness and evidence of corrosion, and wiring for defects
and chafing damage. Assure that switches function properly.
• Check footswitch for damage, loose or missing parts and
security. Assure that footswitch functions properly, is not
modified, disabled or blocked.
• Make sure the material handler is equipped with the proper
capacity chart.
Use extreme caution when
checking items beyond your normal
reach. Use an approved safety
ladder.
Before operating handler, complete
all required maintenance. Replace
or repair all damaged, worn or
missing components before start-
ing or operating handler. Failure to
properly maintain handler could
cause serious injury or death.
WARNING !
WARNING !