JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 20)

A brief description of controls and
instruments is provided here as a
convenience for the operator.
These descriptions DO NOT
provide complete operation
instructions. Read & understand
this Manual, the Transformer
Series Work Platform Manual, the
ANSI A92.5 Responsibilities
Manual, the EMI Aerial Work
Platform Safety Manual, and the
GRADALL Material Handler Safety
Manual.
WARNING !
3.1
Accelerator Pedal: Depress pedal to increase speed and release pedal to
decrease speed.
Attachment Tilt Lever: This lever controls tilt of the fork carriage. Speed is
proportional to lever actuation and engine RPM. Push lever forward to tilt down;
pull lever back to tilt up.
Attachment Tilt Switch (optional): Depress left side of switch to tilt down;
depress right side of switch to tilt up.
Auxiliary Control Lever (optional): This lever is used to control optional
hydraulic attachments. Follow decal instructions for lever/handler movements.
Auxiliary Light Switch (optional): This switch turns auxiliary lights on and
off.
Boom Control Joystick: This joystick controls boom elevation and extension.
Pull joystick back to raise boom; push joystick forward to lower boom. Move joystick
to right to extend boom; move to left to retract boom. Speed of boom movement
is proportional to joystick actuation and engine RPM.
Control Station Selector Switch: Rotate key activated switch to “Platform” to
transfer power to platform controls. Rotate key activated switch to “Cab” to transfer
power to cab controls. When not in use, turn the selector switch to “Off”. If the
switch is not positioned in the “Off” position during shutdown and emergency stop
button is in run mode, the battery will drain.
Decompression Valve: Used only for connecting/disconnecting Auxiliary
Hydraulics. Located in cab, left side of seat pedestal.
Emergency Stop Button: Pushing the button stops engine operation.
Engine Coolant Temperature Gauge: This gauge displays engine coolant
temperature.
Engine Oil Pressure Gauge: This gauge displays engine oil pressure.
Fuel Gauge: This gauge displays level of fuel in fuel tank.
Heater Fan Switch (optional): This switch turns heater fan on and off.
Horn Button: Depress button to sound horn.
DEFROSTER FAN
AIR VENT
AIR VENT
TEMPERATURE CONTROL
HEATER FAN SWITCH
ACCESS COVER/
HEATER VENT
HEATER
OPERATOR’S CAB