JLG 19AMI Operator Manual - Manual (Page 16)

SECTION 1 - SAFETY PRECAUTIONS
1-6 – JLG Lift – 3121189
• Never Operate Or Raise Platform When Machine Is On A
Truck Or Other Vehicle.Approved Head Gear (I.e. Hard
Hat, Etc.) Must Be Worn When Required By All Operating
And Ground Personnel.
• Read And Obey All Danger, Warnings, Cautions And
Operating Instructions On Machine And In This Manual.
• Be Familiar With Location And Operation Of Ground Sta-
tion And Emergency Controls.
1.4 OPERATING SAFETY
• Do Not Operate Any Machine On Which Danger, Warning,
Caution Or Instruction Placards Or Decals Are Missing Or
Illegible.
• Never Exceed Manufacturers Rated Platform Capacity -
Refer To Capacity Decal On Machine.
• Operate Ac Units With An Extension Cord Wire Rated At A
Minimum Of 15 Amps.
• Do Not Enter Platform Until The Floor Brake Has Been
Properly Adjusted And The Unit’s Base Frame Is Level
According To The Bubble Level Indicator On Base Frame.
• Do Not Operate Machine On Soft Footing That Will Allow
The Floor Brake To Settle Into Or Break Through Surface.
• Never Operate A Malfunctioning Machine. If A Malfunction
Occurs, Shut Down The Machine, Remove It From Ser-
vice, And Notify Proper Authorities.
• When Applicable By Reason Of Local Regulations Or Job
Site/Employer Safety Rules, Personnel In The Platform
Shall At All Times Wear Approved Fall Protection Devices
And Other Safety Gear As Required. A Lanyard Attach-
ment Is Supplied On The Side Of The Machine’s Mast.
Always Look in the Direction of Movement.
Watch for Overhead and Other Obstructions.