JLG 19AMI Operator Manual - Manual (Page 41)

SECTION 4 - MACHINE OPERATION
3121189 – JLG Lift – 4-7
Platform Loading
The platform maximum rated load capacity is shown on a plac-
ard located on the platform control panel and is based upon the
following criteria.
Maximum capacity for the 19AMI model is as follows:
* Distribute weight evenly throughout the platform.
Platform Operation
DO NOT ATTEMPT TO RAISE THE PLATFORM UNLESS THE FLOOR
BRAKE IS PROPERLY SET AND MACHINE IS ON A SMOOTH, FIRM,
LEVEL SURFACE.
BEFORE AND WHILE RAISING THE PLATFORM, CHECK CLEARANCES
ABOVE AND AROUND PLATFORM AND MAST TO ENSURE ADEQUATE
CLEARANCE OF SURROUNDING OBJECTS AND PERSONNEL.
1. Enter platform and close the gate/slide bar.
NOTE: On platform control box the FUNCTION ENABLE (green
button) must be depressed simultaneously with either the
PLATFORM UP or PLATFORM DOWN button in order for
these functions to work.
2. To raise the platform up, depress the FUNCTION ENABLE
BUTTON (green) and PLATFORM UP button (top, white
button) on the platform control panel simultaneously.
Upon reaching desired elevation level release PLATFORM
UP and FUNCTION ENABLE buttons.
ENSURE AREA BENEATH PLATFORM IS FREE OF PERSONNEL AND
OBSTRUCTIONS PRIOR TO LOWERING PLATFORM.
3. To lower platform, depress FUNCTION ENABLE BUTTON
(green) and PLATFORM DOWN button (bottom, white but-
ton) on control panel simultaneously. Upon reaching
desired elevation level release PLATFORM DOWN and
FUNCTION ENABLE buttons.
Table 4-1. Maximum Platform Capacity.
Platform Type Platform Capacity Specification
All Platforms
(Except Extendible)
350 lb.* (160kg) ANSI/CSA
Extendible Platform 300 lb.* (135kg) ANSI ONLY