2N Indoor Touch User guide v1.2 - Manual (Page 12)

12
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
a.
b.
c.
3.
a.
b.
4.
2.2 Brief Installation Guide
Install the device holder onto a vertical wall. The recommended installation
height is 120 cm above the floor. The product package includes screws and plugs
for mounting into classic bricks. Use appropriate installation fittings for a different
type of wall material!
Feed the device via an Ethernet PoE adapter (or PoE supporting Ethernet
switch/router) or a 12V DC 2A power adapter.
With PoE supply, just snap RJ-45 into the appropriate connector.
With 12V DC 2A supply, screw the power adapter plus and minus cables
into the appropriate terminal board on the device.
Simultaneous PoE +
! 12V DC 2A supply is not recommended
Put the device on the holder as follows:
Place the device carefully from top to bottom with its bottom part slightly
away (up to 5 cm) from the wall.
When the device fits to the main holder supports, push the device bottom
part onto the wall.
Tighten the safety screws on both the device sides.