2N Indoor Touch User guide v1.2 - Manual (Page 14)

14
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
Use any 12V/2A DC power adapter connected to the terminal board (see the
figure).
Use an Ethernet cable connected to a PoE supply or PoE supporting Ethernet
switch/router.
A successful operation is indicated by a status RGB LED or LCD display.
PoE Supply Connection
Use a standard straight RJ-45 terminated cable to connect to the 2N Indoor Touch
®
Ethernet. The device supports the 10BaseT and 100BaseT protocols. The Ethernet
connection state is indicated by the LEDs placed on the RJ–45 connector.
Refer to
for the factory settings of the 3.3 Launcher Configuration 2N Indoor Touch
®
Ethernet interface.
Licence Limitations
2N Indoor Touch
®
can contain time-limited software licences. Refer to 3.3 Launcher
for details. Configuration
Firmware Upgrade
We recommend you to upgrade the firmware during installation. 2N Indoor Touch
®
Refer to for the latest FW version. Refer to for the www.2n.cz 3.4. Device Upgrade
firmware upgrade procedure.
Caution
Factory reset results in a change of the Ethernet interface configuration!
A defective Ethernet cable may lead to a high packet loss in the Ethernet
and subsequent instability and poor video call quality!
Warning
Connection of a defective or improper power adapter may lead to a
temporary or permanent failure of the 2N
Indoor Touch
®
unit!