2N BRI Lite/Enterprise v1.6 - Manual (Page 76)

76
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Users
This section helps you manage the SMS users. Select a communication protocol for
user adding (SMTP/POP3 or SMPP).
Add user
User group – assign the user to a User group.
User full name – define the system user name.
Replace dial for outgoing SMS – define the number (CPN) to which
the user's outgoing SMS messages shall be sent.
Access type – select the communication protocol for SMS
processing:
Email (SMTP/POP3) – use SMTP for SMS sending and POP3
for SMS receiving.
SMPP (SMSC) – set the GSM gateway into the 'SMS centre'
mode.
SMPP (ESME) – set the GSM gateway into the 'ESME -
External Short Messaging Entity' mode.
Login name (without domain) – define the login name for the
client Email.
System ID – SMSC user
. ID
Password – SMSC/SMTP user password.
System ID (for authentication on remote side)
– ESME user ID.
Password (for authentication on remote side) – ESME user ID.
– set the TCP parameter into the client/server mode. TCP type
Server address – set the server IP address and TCP server
transport port.
Message direction of Esme – set the ESME user details:
Transceiver – ESME works as a transmistter/receiver.
Transmitter – ESME works as a transmitter.
Receiver – ESME works as a receiver.
Address range – set this parameter if required so by SMSC for SMS
receiving.
Delivery status required – set the SMS sending request for
outgoing SMS delivery confirmation
.
Send message as Flash SMS – activate the Flash SMS function for
outgoing SMS messages.
Note
You can set the parameter only if the Delivery status required
SMTP/POP3 protocol is used.
With SMPP, the delivery information is active automatically in case the
service is required by the SMPP counterparty or via an incoming SMS
message from the GSM/UMTS network.