2N NetStar Hardware manual - Manual (Page 19)

19
RES
The Reset button will reboot the
entire system.
Maintenance switch
ON position – appliance switched on
OFF position – appliance switched off, the position is equipped with a 3s
by–pass for the switching into the Maintenance Mode
Maint. position – appliance in the maintenance mode, the line cards supply
switched off and the card drivers stopped in order to enable their maintenance or
exchange, or changes in the port set–up.
After the switching into the ON position, the card drivers are launched and their power
supply is switched on – no need for the re–launching of the entire system and starting
of all processes.