1 select of the installation part – 2N NetStar Hardware manual User Manual

Page 6

Advertising
background image

6

1.1 Select of the Installation part

The following aspects shall be taken into consideration
while selecting a site for the system installation:

Good accessibility:

All  interfaces  for  the  connection  of  the  telecommunication  interfaces  or  data  network
connections, as well as the switch-on, switch-off and system reset controls are placed
on the front side.

Protection against humidity and extreme temperatures:

The appliance may never be placed close to heat sources (radiators) or places exposed
to  direct  sunshine.  Also  places  with  high  humidity  (such  as  bathrooms  and  cellars),
places  with  significant  temperature  fluctuation  (next  to  doors,  windows,
air-conditioning), dusty places (workshops, etc.) or places exposed to aggressive gases
(accumulator room, boiler room) as well as places with intensive vibrations and places
exposed to shocks (compressor rooms, heavy industrial operations) should be avoided.
The system should be installed horizontally.

Installation of infrastructure in the building:

The system was designed for installation in a 19" rack and connection to the structured
wiring  infrastructure  with  termination  at  a  CAT  3  or  CAT  5  patch  panel.  If  the
infrastructure is already ready the switchboard installation site is usually given and can
not be further changes. The interface must however be adjusted for the connection via
RJ 45 8/8 plugs.

GSM signal quality:

If  a  GSM  card  is  a  part  of  your  system  (or  will  become  later  on),  it  is  necessary  to
consider that the cable leading from the GSM card to the GSM antenna is usually 3m
long  (max.  10m).  You  should  ensure  that  within  this  diameter  from  the  selected
system installation site a place with good GSM signal suitable for placement of the GSM
antenna is available. *)

Theft protection:

While  selecting  the  installation  site  the  insurance  company  conditions  should  be
regarded as well.

In the areas with very poor GSM signal level or high number of GSM
gates the use of internal (takes the position of a line card) or external
GSM splitter is advantageous.

Advertising