2N StarPoint manual - Manual (Page 17)

17
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
1.
2.
3.
2.3 During a Call
Switching to HandsFree During a Call
Suppose you are speaking with your handset picked–up, but suddenly you have to put
the handset aside without ceasing to speak. Push the
button. The HandsFree
telephone transits into the HandsFree mode as signalled by the button LED. Now you
can hang up and go on speaking. Push the
button with your handset HandsFree
hung–up to terminate the call.
The function only works with the HandsFree or Speakerphone
supporting terminals.
Handset/HandsFree Volume Control
Use the and buttons to adjust the volume of the handset or HandsFree mode
during a call. The change will apply to the currently active mode (handset/HandsFree).
Microphone Muting
Do you need to consult a colleague of yours or just not to be heard during a call? Use
the
function. Microphone muting is signalled by the button LED flashing. Mute
Re–press the button to switch the microphone on again.
Call Transfer
Suppose you want to transfer your opponent to another telephone number during a
call.
Call Transfer with Hang–Up Procedure:
Push the or programmable button. Flash Call slot
You can hear the dialtone in your handset (the opponent hears music).
Dial the telephone number to which you want to transfer the call.
Hang up after receiving the ringing tone. The two subscribers will get connected.
Call Transfer without Hang–Up Procedure:
Push the or programmable button. Flash Call slot
You can hear the dialtone in your handset (the opponent hears music).
Dial the telephone number to which you want to transfer the call.
Wait until the called subscriber answers the call.
Now you can push
or the respective button to switch between the Flash Call slot
active and held calls.
When you terminate the active call, the held subscribers will be connected.
Call Transfer with Speed Dialling Procedure:
Push the programmable button during a call to which the State/Speed dialling
subscriber number that should receive the transferred call is assigned.
The active call is put on hold and a new call is set up to the required number.