2N StarPoint manual - Manual (Page 46)

46
4.3 Programmable Buttons - Functions
Activate Profile
Use the function to easily activate and deactivate a user profile.
Use:
Push the button with this function to activate the profile. The LED indicator of the
respective button is shining while the profile is active. Re–push the same
programmable button to deactivate the profile, or activate another profile, thus
deactivating the current profile automatically.
CLIR (Identification Restriction)
CLIR means Calling Line Identification Restriction. Use the function to hide your
outgoing identification during call setup.
Use:
Push the function button before dialling the number (before picking up the handset).
The active CLIR state is indicated by a shining button LED. Identification will be
restricted for all subsequently set–up calls. Re–push the button to cancel the function.
The resultant effect of CLIR depends on additional settings of your
PBX for calls outside the PBX. Consult your system administrator in
the event of error.
Default
The programmable button with this "function" helps you use the functions defined by
the PBX administrator. These functions can be "inherited" by connected terminals
unless the user sets a function of its own that is always preferred to the global settings
of the PBX.
Esc (Back)
Use the function primarily to easily quit a menu, cancel current actions, delete edited
symbols and reject incoming calls. It is one of the most important functions of the
terminal, which improves the user comfort above all.
Use:
Whenever the terminal gets into the state in which this function button can be used,
the respective LED indicator will go on.
Flash (Call Holding)
Use the function to put a call on hold for call transferring or consulting purposes. The
function also enables active and held calls to be switched.
Use: