AirLive WHA-5500CPE-PCBA - Manual (Page 70)

4. Manage the WHA-5500CPE
Rebooting the WHA-5500CPE would disconnect any active clients
and therefore will disrupt any current data traffic.
4.10 What if you forgot the password?
Hardware Reset To Factory Defaults
If you forgot the password, the only way to recover is to clear the device configuration and
return the unit to its original state as shipped from the factory.
You can reset the Access Point’s Settings to factory defaults by pushing a paperclip in the
RESET hole on the PCB panel. Push and hold for around 2 seconds until the lights at the
front of the Access Point are off. Doing so will clear your current configuration.
AirLive WHA-5500CPE User’s Manual 64