AirLive WN-200R - Manual (Page 14)

AirLive WN-200R User’s Manual 10
Main Menu
The main menu, on the left, contains links to the most-commonly used screen. To see the links to the other available
screens, click "Advanced" or "Administration".
The main menu also contains two (2) buttons:
• Log Out - When finished, you should click this button to logout.
• Restart - Use this if you wish to restart the Wireless Router. Note that restarting the Router will break any existing
connections to or through the Router.
Navigation & Data Input
• Use the menu bar on the left of the screen, and the "Back" button on your Browser, for navigation.
• Changing to another screen without clicking "Save" does NOT save any changes you may have made. You must
"Save" before changing screens or your data will be ignored.
On each screen, clicking the "Help" button will
display help for that screen.
3.5 LAN Screen
Use the LAN link on the main menu to reach the LAN screen. An example screen is shown below.
Figure 6: LAN Screen
Data - LAN Screen
TCP/IP
IP Address IP address for the Wireless Router, as seen from the local LAN.
Use the default value unless the address is already in use or
your LAN is using a different IP address range. In the latter
case, enter an unused IP Address from within the range used by
your LAN.
Subnet Mask The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the Wireless Router is attached (the same
value as the PCs on that LAN segment).