AirLive WN-200R - Manual (Page 18)

AirLive WN-200R User’s Manual 14
Configure SSID
1/2 Button Click this button to access the Wireless security sub-screen, and
view or change the settings. See the following section for details.
Options
802.11 Mode Select the desired mode:
• Off - Wireless is disabled.
• B only - Only 802.11b connections are available. 802.11g
Wireless Stations will only be able to use the Wireless
Router if they are fully backward-compatible with the
802.11b standard.
• G only - Only 802.11g Wireless stations can use the Wire-
less Router.
• 11b/g/n - 802.11.g, 802.11b and 802.11n Wireless stations
can use the Wireless Broadband Router.
Channel NO. Select the Channel you wish to use on your Wireless LAN.
• If you experience interference (shown by lost connections
and/or slow data transfers) you may need to experiment with
different channels to see which is the best.
• If using multiple Access Points, adjacent Access Points
should use different Channels to reduce interference.
Isolation
between SSID If Enabled, devices that have the different SSIDs will not be able
to communicate with each other.
Bandwidth Select the desired bandwidth from the list.
MAC Address Filter
Allow access
by … Use this feature to determine which Wireless stations can use
the Access Point. The options are:
• All Wireless Stations - All wireless stations can use the
access point, provided they have the correct SSID and secu-
rity settings.
• Trusted Wireless stations only - Only wireless stations
you designate as "Trusted" can use the Access Point, even
if they have the correct SSID and security settings.
This feature uses the MAC address to identify Wireless sta-
tions. The MAC address is a low-level network identifier
which is unique to each PC or network device.
To define the trusted wireless stations, use the "Set Sta-
tions" button.
Set Stations
Button Click this button to manage the trusted PC database.
WiFi Protect Setup
Enable WPS Enable this if you want to use Wireless WPS function.
AP PIN Code Use the default displayed value or click the Regenerate button to
have the new pin code in the field.
Input Client
PIN Code Enter the client’s PIN code in the field and click OK to add the
client device.
WDS
Enable WDS This feature allows you to make a completely wireless network
by using multiple access points without connecting them with a
wire LAN.
In order to make the WDS working successfully, the access
point must use the same channel, SSID, as well as the wireless
encryption method.