AirLive WN-200R - Manual (Page 67)

AirLive WN-200R User’s Manual 63
End Enter the end of the range of port numbers used by the
application server.
Protocol Select the protocol (TCP, UDP or Both) used by the Server.
IP Address Enter the desired IP address.
Enable Use this to Enable or Disable support for this Server, as
required.
6.9 QoS
The QoS (Quality of Service) feature allows you specify priorities for different traffic. Lower priority traffic will be slowed
down to allow greater throughput or less delay for high priority traffic.
An example QoS screen is shown below.
Figure 55: QoS Screen
Data - QoS Screen
QoS Setting
QoS Setting To disable QoS (Quality of Service), keep the default setting,
Disable. To enable QoS (Quality of Service), click Enable and
follow these instructions.
Management
Type There are 2 options:
• Rate Control - The QoS will be managed by the size of the
bandwidth.
• Priority - The QoS will be managed by the priority.
Bandwidth Enter the desired value of the bandwidth.