Online manual not for resale purposes – BLITZ R-FIT-Fuel Intensity Tracer User Manual

Page 9

Advertising

6. Before starting the engine.

Turn the IGN-ON, and check the following contents.

① Did it display the EASY SETUP screen right after powering ON the R-FIT?

If it did not, check the connections again or call our support center.

② Aren't there any abnormalities such as noise and bad odor from or near by the ECU?

If these symptoms appear, promptly stop using the product and call our retailer where it was purchased of

call out support center.

③ Start the engine after following initial setting at V-5 (Pg 11), if the above symptoms are not noticed and it

operates normally.

● Please do not start the engine any means until the initial setting is performed.

There is a possibility of damaging the engine if it is put into operation without

performing the initial settings. Please set up every applicable item according to the

methods of initial setting.

V. Operation method

1. Basic Operation

Operation Button

Basic operation

ＥＮＴＥＲ switch

To confirm each item

ＵＰ and ＤＯＷＮ switch

To select and to decrease or increase the values

ＬＥＦＴ switch

To return to the ＭＡＩＮＭＥＮＵ and to the previous operation .

ＲＩＧＨＴ switch

To clear the peak value (press over 3 sec)

ＬＥＦＴス switch
（ＭＥＮＵ）

ＵＰ switch

ＲＩＧＨＴ switch

（ＰＥＡＫ CLEAR）

ＥＮＴＥＲ switch

ＤＯＷＮ switch

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals