ETC Element v2.1.0 - Manual (Page 153)

11
Cue Playback 141
Other Go To Cue options
When [Go to Cue] is pressed, the softkeys in the CIA are changed to provide Go to Cue modifiers
to enhance your playback ability.
From these softkeys, you can specify that when going to a cue, only some elements of that cue will
be played back. Specifically you can choose to play back:
• single parameter channels only (conventionals),
• [GoTo Cue] [1] {SingleParam} [Enter]
• multiple parameter channels only (moving lights),
• [GoTo Cue] [2] {MultiParam} [Enter]
• move instructions only,
• [GoTo Cue] [3] {MovesOnly} [Enter]
• or you can choose play back a cue and withhold any link (follow, execute instructions) it may
contain.
• [GoTo Cue] [4] {MinusLinks} [Enter]
These can be combined within the command line as well:
• [Go To Cue] [1] {MultiParam} {MovesOnly} [Enter]
[Go To Cue] [4] {Complete} [Enter] will go to cue 4 and if that cue has a follow/hang, any following
cues in the sequence will also fire. This may look like you are going straight to the last cue in the
sequence, but each cue will fire to make sure that any external links are fired.
[Go To Cue] [2] [At] [5][0] {Complete} [Enter] will go to cue 2 at 50% of its completion.
Loading a Cue with Temporary Timing
A cue can be loaded with temporary timing.
• [Cue] [3] [Time] [6] [Load] - loads cue 3 with the manual time of 6.
N o t e : For multipart cues, the temporary time will be applied to the entire cue, not just the
part on the command line.