N o t e – ETC Element v2.1.0 User Manual
Page 197
14
Using About
185
{Device Details} - appears when the current address is patched to a RDM device. RDM devices
must be enabled through the ECU and discovered through the patch. See
and
{Patch} Display and Settings, page 67
.
{Device Details} displays the information that it receives from the device and allows some changes
to be made to:
•
Device Label (displayed at the top by the address number)
•
DMX Address (can be changed in this display by clicking on the property or value)
•
DMX Label (same as the device label, but the label can be changed here by clicking on
the property or value)
•
Type
•
Manufacturer
•
Device ID
•
Footprint
•
Version
•
Lamp State
•
Lamp Hours
•
Head DC Voltage
•
Lamp On/Off
•
Gel Distance Traveled
•
Gel2 Distance Traveled
•
Fan RPM
•
Ambient Temperature
•
Gel Temperature
•
Device Errors (will only display if there are current errors)
•
Clear Errors
Device Errors are displayed in four different colors depending on severity. The severity of the error
is determined by the manufacturer of the device.
•
Gray - Unknown or not an error
•
White - Advisory
•
Yellow - Warning
•
Red - Error
N o t e :
Changes may take a few seconds to take effect. They will propagate to the RDM
device and then back to the console’s patch and about displays.
N o t e :
You may change the starting address on RDM devices, but the port/universe is
fixed by the device’s connection to the gateway. To change the universe., the
device must be connected to a different gateway port in the system.
N o t e :
Details displayed will vary based on the device.