Getting started, Hardware, Power up the console – ETC Element v2.1.0 User Manual
Page 20: Power down the console, Power up the console power down the console
8
Element User Manual
Getting Started
This chapter will quickly get you started with using Element. Later chapters will go into further detail
of topics touched upon here.
Hardware
Power Up the Console
Step 1:
Attach the appropriate power cable to the IEC connector on the rear of the console.
For a diagram of the rear of the console,
See “Console Geography” on page 12.
Step 2:
Press the power switch (I is “on”) under the IEC connector on the rear panel to turn
power on. This will provide power to all internal electronics.
Step 3:
Press the power button, located in the top left corner of the console, above the USB
port. The button LED will illuminate blue to indicate the console is running. The
console will boot up into the Element environment. Element is now ready for use.
Power Down the Console
Step 1:
In the browser menu select Power Off Device. To bring up the browser menu, press
[Displays] twice. A dialogue box opens asking you to confirm.
Step 2:
Confirm this command by pressing [Select] or clicking with a mouse the {OK} button
in the dialog box. The console will power down.
-Or-
Step 1:
Press the power button, located on the face panel. A dialogue box opens asking you
to confirm.
Step 2:
Confirm this command by pressing {OK} in the dialog box or by pressing the power
button again. The console will power down.
N o t e :
For additional information on setting up Element’s hardware, please see the
Element Setup Guide.
N o t e :
Element will display an improper shutdown message on the next power up if the
console was not powered down from the browser menu or welcome screen.
Power button
Level
wheel
Control
keypad
Blackout and
Grandmaster
Faders and
bump buttons
Fader Position
Switch