Garland SHGRIN5000 INDUCTION BUILT-IN GRIDDLES - Manual (Page 13)

Installation Garland RTCSmp Induction Built-in Griddles
Part # 4532291 Rev 2 (01/15/14) 13
4.5.2.2 Drop-In Mounting Instructions
IMPORTANT
To protect the induction unit from water
penetration, you must apply and bond
the silicone adhesive properly to create a
water-tight seal. Before you begin the
installation, it is very important to use
isopropyl alcohol (minimum 70%) or
equivalent to clean the flange and the
counter surfaces where the silicone
adhesive will be applied.
A. Custom built an installation frame or create a flange on the counter surface. This flange will prevent grease
or liquid from penetrating into the cabinet and the induction unit.
Countertop opening dimensions: 523mm x 382mm [20.59” x 15.04”].
B. Apply silicone adhesive PACTAN (part# 70000015, provided with the Air Intake Kit) to the lower end of the
griddle plate and the countertop where the two surfaces will meet. Then carefully lower the unit into the
cut-out.
C. To seal the gap between the rim and the counter surface, apply a thin line of silicone completely around
the edge of the griddle plate.
NOTE: We recommend using a food grade silicone for this application.
NOTE: Allow the silicone to cure for at least 48 hours. Do not start up the griddle during this time.
4.5.2.3 Flush Mounting Instructions
• A mounted frame is included for flush mounting the unit. The frame comes with a leveling plate and a
silicone tube. This frame is to be stud-mounted onto the underside of the counter surface.
• Installers are responsible for choosing the appropriate fasteners for the installation.
Dimensions of Mounting Frame—Single Griddle (measurements in mm and [inch])