Garland SHGRIN5000 INDUCTION BUILT-IN GRIDDLES - Manual (Page 16)

Installation Garland RTCSmp Induction Built-in Griddles
16 Part # 4532291 Rev 2 (01/15/14)
4.6 Electrical Installation
IMPORTANT
• Refer to the electrical specifications in chapter 3 Dimensions and Technical Specifications AND
• Ensure the supply voltage and the line current match the specifications given on the rating plate. A
stable mains supply must be provided.
the
markings/instruction labels on the unit. If the information differs between the data listed in the
manual and the markings on the unit, always follow the markings on the unit.
CAUTION
Wrong voltage will damage the induction unit. Follow
strictly the specifications on the rating plate.
• The electrical connections must satisfy the national and local electrical codes.
• If ground fault current protective switches are used, they must be provided with selective activation and
designed for a minimum fault current of 30mA. Multiple generators with a mains connection must not be
connected to a single fault current protective switch.
• This induction unit is equipped with a power cable which can be connected with the necessary plug to
the socket. Ensure the plug is easily accessible for disconnecting from the power supply. Put the control
knob in the 0 (OFF) position BEFORE connecting to the electrical supply.
To setup the unit for operation:
1. Ensure the control knob is at the OFF-Position.
ON-Position
Any position where
the White Line is
not pointing at ‘0’.
OFF-Position
White Line is
pointing at ‘0’.
2. Remove all objects from the griddle plate.
3. Connecting the components:
A. Use the RJ-45 cable provided to
connect the control unit to the
griddle plate.
B. Ensure the Air Intake Kit is
properly installed. See 4.5.3 Air
Intake Kit Installation.
C. Connect to power supply.
Illustration: Bottom View of a Built-in
unit shown.
4. Test the unit. See chapter 5 Function Test.