General Machine Products 89010 Breeze Micro Fiber Cable Blowing Machine User Manual
Page 20
Page 20 of 43
General Machine Products Co., Inc.
The machine should be returned to the General Machine Products Co,, Inc., Trevose, Pa.
after every 1000 hours use (or at intervals of 12 months) for a major service.
As a general rule, every time an interchangeable part is removed and replaced by a part of a
different size, shape etc. the part being removed should be thoroughly cleaned before being
returned to its box. Similarly the cavity from which it was removed can also be cleaned prior to
the assembly of the replacement part.
Air box parts: Keep clean. A build
up of moisture and dust will pre-
vent the joint faces from mating,
preventing the housing seal from
sealing. Use any traditional work-
shop cleaning agent.
Tube clamp inserts:
Keep clean. A build up of
moisture and dust, partic-
ularly in the grooves, will
reduce the clamping ef-
fect. Use any traditional
workshop cleaning agent.
Cable guide set parts: Keep clean. A
build up of moisture and dust may catch
the cable. This could cause the machine
to stop feeding. Loosen the thumb nuts
and slide back the top plate to expose the
guide groove. Use any traditional work-
shop cleaning agent.