General Machine Products 89000 Cable Blowing Machine(Previous) - Manual (Page 13)

Page 13 of 64 General Machine Products Co., Inc.
ELECTRONIC CONTROL SYSTEM
Power Requirements:
Fuse Rating: 3.15 amp (slow-blow)
DIMENSION AND WEIGHTS
Height:
48 1/2” (1230mm)
Length: 42” (1060mm)
Width:
27 1/2” (700mm)
Weight: 155 lbs. (70kg)
Tire Size:
3.00 - 4 / 260 x 85
Tire Pressure: 25 psi (1.72 Bar )
Drive Chain Lubrication:
Metaflux 70 - 88 Chain Spray
INSTALLATION PRINCIPLE
Basic standard: Viscous Drag Method
Optional:
Missile System
12 Volts DC ( gel cell battery supplied)
Charging the 12 volt battery before use:
Plug in the supplied battery charger in the charging jack found on the
right of the control panel. Initially charge the battery for 8 hours before
use (to approximately 13 volts). Continuous charging of the battery with
your charger will reduce the life of the battery. Remove the charger
when charging is complete. When voltage dips to 12 volts, recharge the
battery. Optimize battery life by turning off the display when not in use.