General Machine Products 89000 Cable Blowing Machine(Previous) - Manual (Page 32)

Page 32 of 64 General Machine Products Co., Inc.
GENERAL
The machine should be stored under cover when not in use. The machine should be wiped
clean after each time used.
ALWAYS
ensure that there are sufficient cable seals, cord seal, cord adhesive and silicone
grease available in the toolbox to cover the next installation.
ALWAYS
ensure that the battery is fully charged, before the cable blowing machine is to be
used. Note: The battery is not charged by the power pack. The machine uses a conventional
gel cell battery and is charged through the Battery Charger Connection (see below).
CHECK
the tire pressures and condition weekly. Oil the frame pivot points monthly and lubri-
cate the Oilite bearings with light machine oil every month. Apply grease to the jacking screw
thread each month. Clean out any dirt/debris from the cable-measuring wheel, measuring
disc and speed pick up probe.
Oil air chamber adjusting screw and cable infeed guide adjusting screw monthly.
Grease axles every month. Check function of electrical panel each time.
SERVICE CONNECTIONS
CHECK
the condition of the hydraulic hoses each time they’re used and replace if worn or
damaged.
CHECK
the condition of the emergency stop cable each time it’s used and replace if worn or
damaged.
CHECK
the condition of the compressed air hose each time and replace if worn or damaged.
Charging the 12 volt battery before use:
Plug in the supplied battery charger in the charging jack found on the
right of the control panel. Initially charge the battery for 8 hours before
use (to approximately 13 volts). Continuous charging of the battery with
your charger will reduce the life of the battery. Remove the charger
when charging is complete. When voltage dips to 12 volts, recharge the
battery. Optimize battery life by turning off the display when not in use.