General Machine Products 89000 Cable Blowing Machine(Previous) - Manual (Page 35)

Page 35 of 64 General Machine Products Co., Inc.
PROCEDURE DAILY WEEKLY MONTHLY
Clean all assemblies and components thoroughly
Inspect hydraulic hoses for leaks and cracks
Inspect fasteners, screws and retaining pins / wire
Check / adjust chain tension
Check tractor drive pads for wear / damage
Clean air chamber
Check / replace cord seals
Check / replace cable seals
Tire pressure / condition
Check condition of emergency stop lead
Clean rod infeed guide bracket and collets
Clean measuring wheel measuring disc and speed pick
up probe
Function of electronic panel
Oil the frame pivot points
Grease jacking screw thread
Oil air chamber adjusting screw
Oil Oilite bearings with light machine oil
Grease mounting frame axles
Clean and lubricate chain*
Clean and lubricate the chain support slide bars
Check the condition of service and spare 12V DC battery
Check condition of the compressed air hose
7.1. MAINTENANCE SCHEDULE
* Should be more often if subjected to abnormal use and / or excessive contamination.