GeoDesy FSO GeoData20 series - Manual (Page 14)

14
Step 5. Enter the default password, and then press the Login button to enter the APC web
management page.
Step 6. Navigate to the Configuration | Network tab and choose the bridge network mode
with, Dynamic IP enabled (be sure that AP to which the device will be associated has a DHCP server
running ((refer to the section Initial AP Setup for instructions)), specify the DHCP fallback settings in
case the DHCP server will be unreachable and click Save Apply button:
Step 7. Navigate to the Configuration | Wireless tab, choose Station WDS wireless mode,
click Scan button near the SSID entry field to choose the SSID of the AP where the station will be
associated to. Specify the Security parameters for the AP, check IEEE mode (these settings must
conform to AP wireless settings) and click Save Apply: