GeoDesy FSO GeoData20 series - Manual (Page 41)

41
Basic Settings
Use this section to setup basic operating settings of the iPoll Station radio.
iPoll Access Point and iPoll Station will operate in 802.11n IEEE mode only.
SSID
– specify the SSID of the wireless network device manually, or use Scan functionality.
Scan
– click this button to scan for surrounding iPoll Access Points. Found network SSID‟s will be
Available in drop down menu.
Channel width
– The default channel bandwidth for 802.11 N radio is 20/40MHz. The 802.11n allow
channel bonding in such way the total channel width becomes 40MHz.
Security Settings
Both sides (iPoll Access Point and iPoll Station) of the link must have the same security
settings.
The APC device working, in iPoll Station wireless mode, supports authentication/encryption methods
listed below:
 Open – no encryption.
 Personal WPA – preshared key encryption with WPA using AES method.
 Personal WPA 2 – preshared key encryption with WPA2 using AES method.
By default there is no encryption enabled on the device:
Personal WPA/WPA2 encryption must be specified with the pre-shared key:
Passphrase
– specify the WPA or WPA2 passphrase [8-63 characters]. The passphrase will be
converted to key format, selected above.
Advanced Wireless Settings
Advanced wireless settings allow configuring the APC unit to get the best performance/capacity of the
link: