GeoDesy FSO GeoData20 series - Manual (Page 25)

25
Management VLAN
Available only on Bridge network mode.
Access to the AP for management purposes can further be limited using VLAN tagging. By defining
Management VLAN, the device will only accept management frames that have the appropriate
Management VLAN ID. All other frames using any management protocol will be rejected.
When you specify a new management VLAN, your HTTP connection to the device will be lost. For
this reason, you should have a connection between your management station and a port in the
new management VLAN or connect to the new management VLAN through a multi-VLAN router.
Enable
– select to enable a VLAN tagging for management traffic.
Management VLAN ID
– specify the VLAN ID [2-4095]. When device interfaces are configured with a
specific VLAN ID value, only management frames that matching configured VLAN ID will be accepted
by device.
Restrict management to interfaces
– select interfaces that will be restricted with management
VLAN.
7.2.3 Router Mode
This section allows customizing parameters of the Router to suit the needs of network, including
ability to use the built-in DHCP server. W hen device is configured to operate as Router, the following
sections should be specified: W AN network settings, LAN network settings and LAN DHCP settings.