GeoDesy FSO GeoData20 series - Manual (Page 40)

40
the distance, the higher transmit power is required. To set transmit power level use the slider or enter
the value manually. When entering the transmit power value manually, the slider position will change
according to the entered value. The maximum transmit power level is limited to the allowed value by
country in which device is operating regulatory agency.
Enable ATPC
– select to enable Automatic Transmit Power Control (ATPC). If enabled, device radio
will continuously
communicate with remote unit’s radio in order to adjust the optimal transmit power
Automatically.
Antenna Gain, dBi
– displays integrated antenna gain in dBi. This entry field will be editable for the
connectorized antennas where the custom value of the antenna gain must be specified.
Comply regulations – if enabled, the APC will automatically adjust radio settings (transmit power and
DFS) to conform regulatory rules of the selected country.
Enable DFS
– select to enable radar detection. With enabled DFS, APC unit monitors the operating
frequency for radar signals. If radar signals are detected on the channel, the unit randomly selects a
different channel.
Mode
– choose the unit’s antenna operating mode:
 SISO – single input single output. The device will use only one antenna for data transfer. The
antenna will be chosen automatically.
 MIMO – multiple input multiple outputs. The device will use two antennas for data transfer (two
Simultaneous streams).
Max data rate
– select the device data transmission rates in Mbps from the drop-down list. The APC
Will attempt to transmit data at the highest data rate set. If there will be an interference encountered,
The APC will step down to the highest rate that allows data transmission.
Transmit queue length, frames
– specify the length in frames of the transmit queue.
7.2.8 Wireless Mode: iPoll Station
The iPoll Station is a wireless client mode which can connect to the iPoll Access Points.