GeoDesy FSO GeoData20 series - Manual (Page 28)

28
WAN mode
– choose PPPoE to configure WAN interface to connect to an ISP via a PPPoE:
MAC address
– specify the clone MAC address if required. The ISPs registers the MAC address of the
router, and allows only that MAC address to connect to their network. In such case if there is need to
change hardware (router), you need to notify your ISP about MAC address change, or simply set
The router’s MAC address to the MAC address of the previously router/computer.
VLAN ID
– specify the VLAN ID for traffic tagging on required radio interface [2-4095]. The Station
devices that associate using the particular SSID will be grouped into this VLAN.
User name
– specify the user name for PPPoE.
Password
– specify the password for PPPoE.
MTU
– specify the MTU (Maximum Transmission Unit). The default value is 1500 bytes.
DNS settings
– allows selecting if automatically assigned or alternative DNS servers should be used.
Enable IP alias
– specify the alternative IP address and the netmask for APC unit management.
LAN Network Settings
LAN network settings includes settings related to the LAN interface