Detection mode settings” on p. 23, Detection mode settings – INFICON Extrima Ex-certified Hydrogen Leak Detector User Manual
Page 23
23
EN
INFICON - Operating Instructions EXTRIMA
2 3
4
5
1
Detection Mode Settings
Esc < > Enter
Detection Mode Settings
Sensitivity
Esc < > Enter
Detection Mode Settings
Undo + – Save
Set Sensitivity
Low Mid High
Detection Mode Settings
If Direct Sensitivity Adjustment is OFF,
Sensitivity can be adjusted as described
below.
The chosen Sensitivity will only be sto-
red in memory if adjusted in the menu
system.
Select the main menu Detection Mode
Settings as described in ”Detection Mode
Settings” on p. 18.
1. Press Enter.
2. Select:
Sensitivity
Range Settings
Direct Sensitivity Adjustment
Leak Alarm Indication or
Lowest Frequency using < and >.
3. Press Enter.
4. Adjust the desired parameter using
the + and – buttons or < and > de-
pending on submenu.
5. Press Save or Enter to save the set
value. The setting scale will flash to
confirm the setting.
NOTE:
Detection Mode settings
only affects Detection Mode. To
calibrate the Analysis Mode, see
”Calibrate” on p. 21.
NOTE:
Press Undo or Esc to de-
lete the setting and revert to the
previous value.
8
Sensitivity