INFICON DataFID Portable Flame Ionization Detector for Leak Detection and Repair (LDAR) - Manual (Page 59)

074-578-P1A 59
enter password
Logging Off mode displays instantaneous readings only. The display is updated continuously
and readings are not logged.
Location mode displays instantaneous readings. The user has the option to manually store the
instantaneous reading as either a data point with a tag and a sample reading.
Interval mode displays the instantaneous reading. In Interval mode data is logged at a user
selected interval value between 1 second and 999 seconds.
To access the User Mode Section:
1. Press the MENU soft key and select “DataFID Setup”.
2. Select User Mode and then press the SELECT soft key. Press the UP or DOWN
ARROW soft key to choose the applicable User Mode, that is, Logging Off, Location,
Interval, or Method 21.
3. Press SELECT soft key to return to the main display.
Clock
The Clock function is used to set both the current date and time.
Entering Numbers with the Soft Keys to Set the Clock
For all information entry in clock mode, the left, center and right soft keys correspond to the up,
down, and right arrow. See Figure 29. The up and down arrows are used to change the
character highlighted by the cursor. The right arrow is used to advance the cursor to the next
character on the right. To accept the changes, press the DONE soft key.
Figure 29. Setting the Time
To set the time and date:
1. From the DataFID Setup, use the Up or Down arrow soft key to select the Clock
option. Press the SELECT soft key. This allows you to edit the current time and to
edit the current date.
Enter current time
15:45
done