2 controller specifications, 6 unpacking and inspection – INFICON CI-100 Crucible Indexer User Manual
Page 15
1 - 5
IP
N 07
4-
54
4-
P1
B
CI-100 Crucible Indexer Operating Manual
1.5.2 Controller Specifications
Pockets. . . . . . . . . . . . . . . . . . . . . . . Up to 8
Inputs/Outpus . . . . . . . . . . . . . . . . . . Binary or BCD Encoded
Low 0 to 2 V (dc), High 4 to 24 V (dc),
non-isolated
Communication . . . . . . . . . . . . . . . . RS-232 only
Size (H x W x D). . . . . . . . . . . . . . . . 3.5 x 8.4 x 7.8 in. (88 x 213 x 197 mm)
Weight . . . . . . . . . . . . . . . . . . . . . . . 6 lbs. (2.7 kg)
Power . . . . . . . . . . . . . . . . . . . . . . . . 20 W
NOTE: The CI-100 uses a four rotation full cycle. This means that after four full
turns of the motor, it is considered to be back at the home position. Crucible
gearing can be adjusted to match this requirement. For example, if you
have a four discrete pocket crucible, the gearing should be designed so
that one full turn of the CI-100 motor moves one pocket position. For eight
pockets, a half turn should move one pocket position.
1.6 Unpacking and Inspection
1
If the CI-100 has not been removed from its packaging, do so now.
2
Carefully examine the contents for damage that may have occurred during
shipping. This is especially important if you notice obvious rough handling on
the outside of the container. Immediately report any damage to the carrier and
to INFICON.
3
Do not discard the packing materials until you have taken inventory and have
at least performed successful installation.
4
Take an inventory of your order by referring to your order invoice and the
information contained in
5
To set the controller, see
6
For additional information or technical assistance, contact INFICON, refer to