INFICON CI-100 Crucible Indexer - Manual (Page 35)

4 - 1
IP
N 07
4-
54
4-
P1
A
CI-100 Crucible Indexer Operating Manual
Chapter 4
Computer Interface
4.1 Introduction
The CI-100 Controller’s front panel controls and rear panel dip switches will provide
adequate operation and setup capabilities for most users. The rear panel digital I/O
also allows basic operation for system controllers.
For programming the custom pocket configuration, and computer-controlled
operation, use the RS-232 communication interface.
4.2 Control Program
A simple Windows
®
program is supplied to configure, operate and program the
CI-100.
NOTE: The Manual/Auto DIP switch must be in Auto position to communicate
using this program. If it is desired to have complete control of the CI-100
through the software, set the Control grid to Comm and hit send.
Figure 4-1 Program Main Screen