INFICON SKY CDGxxxD (DeviceNet) - Manual (Page 14)

14
tira51e1 (2009-01) CDGxxxD.cp
Attribute ID Access rule NV/
V
Name DeviceNet data type Description of attribute
14 Get V Exception detail
warning STRUCT of: A structure of three structures containing
a bit mapped representation of the
warning detail
Common exception
detail STRUCT of:
Size 2 USINT Number of common detail bytes
Detail 0 ARRAY of: → "Semantics" section below.
Detail 1 BYTE → "Semantics" section below.
Device exception
detail STRUCT of:
Size 3 USINT Number of device detail bytes
Detail 0 BYTE → "Semantics" section below.
Detail 1 BYTE → "Semantics" section below.
Detail 2 BYTE → "Semantics" section below.
Manufacturer
exception detail STRUCT of:
Size 1 USINT Number of manufacturer detail bytes = 1
Detail 0 ARRAY of: Manufacturer specified
15 Set NV Alarm enable BOOL → "Semantics" section below.
16 Set NV Warning enable BOOL → "Semantics" section below.
101 Get NV Software revision
base unit
SHORT STRING ASCII text, for example "010000"
102 Get V Run hours UINT 1 = 1 hour
This attribute represents the current state of the device. Its value changes as the
state of the device changes. The following values are defined:
Attribute value State
0 Undefined
1 Self
testing
2 Idle
3 Self-test
exception
4 Executing
5 Abort
6 Critical
fault
In case of a self-test exception restart the device with a reset out of the box
(identity object class 1, instance 1, service 5, service target value: 1).
A single byte attribute whose value indicates the status of the alarms and warnings
for the device. The device supports the expanded mode.
For the expanded mode, bit seven of exception status attribute is set to one;
exceptions are reported through the communication of this exception status at-
tribute, formatted as specified in the table below. In addition, the exception detail
attributes are supported. The exception status bits are determined by a logical
"OR" of the related exception detail bits, as indicated.
4.3.3 Semantics
Device status
Exception status