2 interface connection – INFICON SKY CDGxxxD (DeviceNet) User Manual
Page 7
tira51e1 (2009-01) CDGxxxD.cp
7
2 Interface
Connection
For operating the temperature controlled CDGxxxD gauge via DeviceNet, an
interface cable conforming to the DeviceNet standard is required.
If no such cable is available, make one according to the following indications.
A shielded special 5 conductor cable conforming to the DeviceNet standard has to
be used (
→ [4] and [5]).
n
Make the DeviceNet interface cable according to the following indications:
3
1
4
2
5
Micro style, 5 pins,
(DeviceNet)
female, soldering side
Pin
1 Drain
Pin 2 Supply
+24 VDC
Pin 3 Supply common GND
Pin
4 CAN_H
Pin
5 CAN_L
Pin assignment of the D-Sub 15-pins sensor connector according to the
respective operating manual (
→ [1], [2], [3]).
o
Plug the DeviceNet (and sensor) cable connector into the gauge.
Sensor cable
DeviceNet cable
p
Lock the DeviceNet (and sensor) cable connector.
Making a DeviceNet interface
cable
Cable type
Procedure